Skip to contentSkip to conversation

iptables+iproute2+squid

LARTC Martin Kellner 2 participants 3 messages Sep 23, 2001 – Sep 26, 2001

lore
Share & tools
lore
#0 lore raw

I think this is the right place to ask:

I'm using
- kernel 2.4.9
- iptables as firewall
- iproute2 with rule-based routing.
- squid

two internet-connection:

- 1 ADSL-based link with dynamic ip-adresses
- 1 static isdn-line with fixed ip-adresses

Everything is working but squid isn't. Any idea why? how is the loopback-traffic handled with my two new tables? Squid uses to work as a transparent-proxy with all the iptables-stuff. When I'm working with the normal routing-tables and one internet-connection. Everything is ok.

I use two rules (first for user-browsing, second for mail-traffic):

ip rule add from 192.168.1.128/25 table www.out
ip rule add from 192.168.1.6 table mail.out

# default route is reset to p-t-p-adress of ppp, when ppp comes down again,
because of idle-state
ip route delete default
# this part is done dynamically when ppp comes up
ip route add default via x.x.x.x table www.out
ip route add 192.168.1.0 via y.y.y.y table www.out
# this part is setup with the firewall start
ip route add default via z.z.z.z table mail.out
ip route add 192.168.1.0 via y.y.y.y table mail.out

Thanks in advance

Martin Kellner

#1 lore raw
Quoted 1 line · On Sun, Sep 23, 2001 at 09:04:14PM +0200, Martin Kellner <[email protected]>…

Everything is working but squid isn't.

BTW, Squid allows you to set the source IP address, which is convenient in similar cases (we have a setup which is close from yours).

Otherwise, can you check Squid's cache.log to see if something is logged?

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://ds9a.nl/2.4Routing/

#2 lore raw
In reply to Martin Kellner
Quoted 5 lines · Stephane Bortzmeyer

On Sun, Sep 23, 2001 at 09:04:14PM +0200,
Martin Kellner <[email protected]> wrote
a message of 100 lines which said:

Quoted 8 lines
Quoted 1 line

Everything is working but squid isn't.

BTW, Squid allows you to set the source IP address, which is convenient in similar cases (we have a setup which is close from yours).

Otherwise, can you check Squid's cache.log to see if something is logged?

It's working now. My router is based on a suse 7.1 distribution. I removed all the network- and routing-initialisation-scripts. It is now done with iproute2-commands. The problems came somehow from how the lo-device was handled.

There are still some messages in /var/log/messages coming from my iptables-script but it is ok.

Thank you
Martin Kellner

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://ds9a.nl/2.4Routing/